Light-gauge metal stud framing for commercial interiors, exterior non-bearing walls, and load-bearing cold-formed steel structures.
Small towns like Cut Bank are where we're from — Edge Enterprise is headquartered in Long Prairie (pop. 3,400), so we understand Glacier County building the way locals do. Edge Enterprise LLC serves Cut Bank with steel framing built on 25+ years of experience and a portfolio that includes some of the region's largest multi-family frames.
Cut Bank sits roughly 17 hr 30 min from our Long Prairie HQ. For multi-week framing packages we stage crews locally, so drive time never becomes your schedule's problem. Montana projects run under the state-adopted IBC/IRC; in mountain-zone jurisdictions, site-specific snow loads and seismic detailing are a fact of life we build for. Typical design values for the Cut Bank area — ground snow load around 50–100+ psf (site-specific in mountain zones), design wind speeds of 105–115 mph; seismic detailing applies in western MT, and frost depths near 48–72 in. — are baked into how we detail and build here; final values are always confirmed with the local building official.
Load-bearing CFS, curtain-wall infill, shaft walls, and ceiling framing — screwed, welded, or clipped per the engineer's details.
Demising walls, furring, soffits, and hard-lid ceilings for tenant improvements and new commercial construction.
Plenty of buildings mix wood and steel. Because we self-perform both, the interface details actually get built the way they were drawn.
Yes — Edge Enterprise self-performs light-gauge steel framing for commercial interiors, exterior infill walls, and load-bearing cold-formed steel projects in Cut Bank and across Montana.
It depends on the building type, code requirements, and finish schedule. Steel wins for non-combustible construction and long interior runs; wood usually wins on cost for low-rise structures. Since we frame both, we'll give you an honest comparison rather than steering you to the only thing we sell.
Yes — shaft liner, area separation walls, and rated demising assemblies are part of nearly every commercial and multi-family steel package we frame.
Absolutely. We regularly contract the metal-stud scope alone — interiors, soffits, or exterior infill — working alongside the GC's other framing subs.
Tell us about your build. We'll get back to you with a clear, honest scope and estimate — typically within one business day.
Request a Free Estimate